Microsoft 550 5.7.509: "does not pass DMARC verification"

The sending domain has p=reject and the message failed DMARC. Whether it is a spoofing attempt or a service you forgot to set up.

550 5.7.509 Access denied, sending domain example.com does not pass DMARC
verification and has a DMARC policy of reject.

The domain in the From address publishes p=reject, and this message failed DMARC, so Microsoft refused it, exactly as the domain owner asked. Whether that's good news depends on who sent the message.

If you received this bounce for mail you sent

One of your own services is not set up correctly. Typical cases:

  • A tool that sends as your domain (CRM, invoicing, website, scanner) without DKIM for your domain and without being in your SPF record.
  • SPF passes for the tool's own domain, which doesn't count for DMARC.
  • A gateway, signature tool or disclaimer service changes the message after it was signed, so DKIM breaks.
  • The message was forwarded, or sent through a mailing list, on the way. See forwarding and mailing lists.

Fix the sending service by enabling DKIM with your domain, then test again. If you moved to p=reject recently and several services break, go back to p=quarantine while you fix them rather than to p=none.

If the bounce is for mail you never sent

Someone sent mail with your domain in the From address, and your reject policy stopped it. The bounce reached you because the forged message used your address as the envelope sender too. You can ignore these; see someone is sending email from my domain.